extreme lacp設定
LACP(LinkAggregationControlProtocol)設定.以下指令將e2/0/1、e2/0/2、e2/0/3進行LACP網路頻寬合併設定。[4500]interfacebridge-aggregation1,ThedefaultvaluefordefaultedLAGportsisdeletethedefaultports.Note.AlwaysverifytheLACPconfigurationbyissuingtheshow...
ThedefaultvaluefordefaultedLAGportsisdeletethedefaultports.Note.AlwaysverifytheLACPconfigurationbyissuingtheshowportssharingcommand; ...
** 本站引用參考文章部分資訊,基於少量部分引用原則,為了避免造成過多外部連結,保留參考來源資訊而不直接連結,也請見諒 **
此文章參考的來源相關文章推薦
3Com 4500G
LACP (Link Aggregation Control Protocol) 設定. 以下指令將e2/0/1、e2/0/2、e2/0/3 進行LACP 網路頻寬合併設定。 [4500] interface bridge-aggregation 1
Configuring LACP - Product Documentation
The default value for defaulted LAG ports is delete the default ports. Note. Always verify the LACP configuration by issuing the show ports sharing command; ...
EtherChannel PAgP LACP 以太通道
設定方法有三種:分別是Static (On Mode),PAgP (Port Aggregation Protocol) 和LACP (Link Aggregation Control Protocol)。其中PAgP 是Cisco 專有,只有Cisco 產品上 ...
Extreme 基本設定@ 好宅不好宅
2017年3月4日 — Extreme 基本設定 · 1.查配置. #show accounts 查看帳號 · 2.Vlan配置. 1建立VLAN · 3.編輯檔案. #ls 條列Switch檔案 · 4.備份檔案. # tftp put 192.168.*. · 5 ...
ExtremeOSSLX
2022年12月4日 — Config'd LACP MAC : None Current LACP MAC : 00:04:96:ae:b2:bf ... #設定相關指令. #設定設備的時間 # configure. Entering configuration mode terminal
《分享》Extreme Summit Switch的基本設定
2014年11月12日 — 與其它廠牌對接時,建議採用標準的LACP (Link Aggregation Control Protocol)。 例如,將1,2,3,4 port組成一個LACP Group,指令如下。 #enable sharing 1 ...
列印預覽
2014年11月12日 — 其中選用參數LACP為sharing group的組成協定。若未指定,預設為static。 與其它廠牌對接時,建議採用標準的LACP (Link Aggregation Control Protocol)。
喬家大院
2013年1月3日 — 系統重開之後就回預設值,所有的設定都會不見。 LACP: 8810 config enable sharing 2:47 grouping 2:47-48 algorithm address-based L2 第一個「2:47 ...